Floppy Disk Drive Problems; Hard Drive Problems; Keyboard Or Mouse Problems - Fujitsu LifeBook S6000 Manual

Problem
Notebook fails to recognize
DVD/CD-RW/CD-ROM's.
(continued)
The DVD/CD-RW/CD-
ROM Access indicator on
the Status Indicator Panel
blinks at regular intervals
when no DVD/CD-RW/
CD-ROM is in the tray or
the DVD/CD-RW/CD-
ROM drive is not installed.

Floppy Disk Drive Problems

You cannot access your
floppy disk.

Hard Drive Problems

You cannot access your
hard drive.

Keyboard or Mouse Problems

The built-in keyboard does
not seem to work.
You installed an external
keyboard or mouse and it
does not seem to work.
Possible Cause
DVD/CD-RW/CD-ROM is
dirty or defective.
The Windows DVD/CD-RW/
CD-ROM auto insertion func-
tion is active and is checking to
see if a DVD/CD-RW/CD-
ROM is ready to run.
You tried to write to a write
protected floppy disk.
Floppy disk is not loaded
correctly.
The floppy disk drive may not
be properly installed.
Security is set to protect access
to floppy disk data.
The setup utility is incorrectly
set for your internal (Primary
Master) or optional second
hard drive (Primary Slave).
The wrong drive designator was
used by an application when a
bootable CD-ROM was used to
start the notebook.
Security is set so your operating
system cannot be started
without a password.
The notebook has gone into
Suspend mode.
Your application has locked out
your keyboard.
Your external device is not
properly installed.
Your operating system software
is not setup with the correct
software driver for that device.
T r o u b l e s h o o t i n g
Possible Solutions
Wipe DVD/CD-RW/CD-ROM with a non-abrasive
CD cleaning cloth and reinsert. If it still will not
work try another disc in the drive.
This is normal. However, you may disable this
feature.
Eject the floppy disk and set it to write enable.
(See Preparing a Disk for Use on page 37 for more
information)
Eject floppy disk, check orientation and re-insert.
(See Ejecting a Disk on page 37 for more information)
Remove and re-install your floppy disk drive.
Verify your password and security settings.
Revise BIOS settings to set both Primary Master
and Primary Slave correctly. (See BIOS Setup Utility
on page 29 for more information)
Verify drive designator used by application is in
use by the operating system. When the operating
system is booted from a CD, drive designations
are automatically adjusted.
Verify your password and security settings.
Push the Power/Suspend/Resume button.
Try to use your integrated pointing device to restart
your system.
Re-install your device. (See Device Ports on page 45
for more information)
Check your device and operating system docu-
mentation and activate the proper driver.
53