Table of Contents
Advertisement
1.
Rear mounting (2 brackets are pre-installed)
Use 2 screws (If it is not wooden wall, please use anchor.) and 2 washers
to secure the hood to the wall.
2.
Top mounting
Use 4 wooden screws and 4 washers to secure the hood to the bottom of the
cabinet. Lift hood onto screws located on cabinet bottom and lock into place.
Make sure all 4 key-holes cover the screws. Tighten each screw to secure
hood to cabinet. (see FIG.2)
Stick the two round rubber stands on the sides of hood's top(see FIG.3).
(Note: Make sure all 4 key-holes cover the screws and each screw was
tightened. Otherwise, there will be potential risk of machine falling down.)
M
OUNTING
696mm
FIG.1
FIG.2
4
M
ETHOD
FIG.3
Advertisement
Table of Contents
