Page 4
1. WARNING-TO REDUCE THE RISK OF FIRE ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: a.) Use this unit only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer. b.) Before servicing or cleaning unit, switch power off at service panel. c.) Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, Including Fire-Rated construction.
Page 5
‧Packaging materials(plastic bags,polystyrene,etc) must be kept out of children’s reach, as they are potentially dangerous. ‧Installation must be carried out by a qualified technician. ‧Check the voltage on the rating plate which should corresponds to the voltage in your home. ‧Connect the power and switch on the motors and lighting system to check the Operation.
Page 6
1. Find a suitable installation position of hood which should be next to a window and can be cut to let the exhaust duct pass through. Exhaust duct 2. If the exhaust duct has to pass through the wall , particular attention must be paid to the structure of the wall as steel reinforcement may be embedded.
Page 7
PERATION Left Blower Control Right Blower Control Low Speed High Speed Blower On/Off Light On/Off Light On/Off Light switch. " I " means light ON; " o " means light OFF. Blower On/Off Master Fan Power Switch. " I " means blower ON; " o " means blower OFF.
Page 8
1. Always disconnect from power supply before cleaning. 2. Clean both exterior and interior of the hood long lasting. Do not use abrasive cleanser. 3. Fan protection grille can be detached for Remove cleaning by removing the screws with a screwdriver.
Page 9
dangerous 3. There shall be adequate ventilation of the room when the range hood is used at the same time together with appliances in burning gas or other fuels. dangerous 6. The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels 7.
Need help?
Do you have a question about the HE36W and is the answer not in the manual?
Questions and answers