Table of Contents
Advertisement
Fault
The programme does not
start.
The door cannot be opened. The temperature is too high.
The water is not draining.
Water is not flowing in. De-
tergent is not being dis-
pensed.
Cause
- + is activated.
Laundry is caught in the
door.
Water level is too high.
Power failure.
Drain pipe or water outlet
hose is blocked.
Drain pipe or water drain
hose is caught or jammed.
Drain pump is blocked.
The water outlet hose is con-
nected too high.
Pump cover is not correctly
assembled.
Pump cover is not correctly
assembled.
You have not pressed
The filter in the water inflow
is blocked.
The tap is turned off.
The water inlet hose is
kinked or jammed.
troubleshooting
Check whether - + is activated.
▶
→ "Buttons", Page 24
Open the door again.
1.
Remove any trapped laundry.
2.
Close the door.
3.
Press
to start the programme.
4.
Wait until the temperature has
▶
dropped.
→ "Cancelling the programme",
▶
Page 38
Start the Drain programme.
▶
Open the door using the emergency
▶
release.
→ "Emergency release", Page 54
Clean the drain pipe and the water
▶
outlet hose.
Ensure that the drain pipe and wa-
▶
ter drain hose are not kinked or
trapped.
→ "Cleaning the drain pump",
▶
Page 42
Install the water outlet hose at a
▶
maximum height of 1 metre.
→ "Technical specifications",
Page 59
Correctly assemble the pump
▶
cover.
Correctly assemble the pump
▶
cover.
.
Press
.
▶
"Clean the water inflow filter"
▶
→ Page 46.
Turn on the tap.
▶
Ensure that the water inlet hose is
▶
not kinked or jammed.
Troubleshooting en
49
Advertisement
Table of Contents
