Advertisement
Repeated address settings - write into the list of addresses those elements with which you want the
eLAN RF. If you set the eLANs to the router mode, the same addresses must be set for both eLANs...
After setting the function Repeater, eLAN restarts.
Router
The Router function is used to extend the distance and control of RF elements by connecting two
eLANs into the LAN network.
The first eLAN (so-called Master ) must be set during configuration in the Router function, it
receives all RF commands of controllers via an RF signal. It assess the limitations and
permissions of addresses.
The second eLAN (so-called Slave) assess all commands from the eLAN Master determined
for sending by RF signal. It sends valid messages by RF signal to controlled elements. If a
response comes from an element, it sends it to the eLAN Master.
It is necessary to enter into the settings the LAN parameters of the second eLAN - Slave (IP
address, login data).
The second eLAN Slave can be configured in two ways.
Active function Repeater – this receives commands via the Ethernet network and via the
RF network.
Example: eLAN Slave catches the RF signal of the RF controller, saves it as Repeater
(signal repeater), and sends the RF signal further along.
Active function Router – eLAN is in its basic setting. eLAN only receives commands from
the Ethernet network, and ignores all RF signals.
Oasis Compatible
The sames as with the Repeater function.
RF Touch Compatible
The sames as with the Repeater function.
List of addresses
The sames as with the Repeater function. The same addresses must be set for both eLANs.
After setting the function Router, eLAN restarts.
15.11.2019
02-32/2017 / rev.7
15.11.2019
eLAN-RF-Wi-003
11 of 17
Page
Advertisement
