Introduction - Salient Features - RHINO RMCS-3002 Operating Manual

Rhino Motion Controls RMCS-3002 with UART ASCII is a high performance brushless dc drive (10–30 V DC)
designed for optimized operation of Rhino brushless DC motors with Hall sensor feedback. This is an amazing cost
effective solution to provide closed loop/open loop control for various applications. The salient features of this drive:
•
This drive provides a closed loop/open loop speed control for the brushless dc system.
•
The motor programmed speeds are maintained irrespective of the voltages supplied.
•
Also by using this drive, the rated torque of the motor is available at all speeds and the torque does not
decrease with change in speeds.
•
It is possible to run the motor in four different modes.
•
It has short-circuit protection for the motor outputs, over-voltage and under-voltage protection and will
survive accidental motor disconnects while powered-up.
•
This drive is configured using MODBUS ASCII protocol via UART.
•
There is a function in the drive for setting the Modbus Slave Address from 1 to 7 using physical jumpers
(Hardware Setting) or using MODBUS Tool Device (Software Setting).
•
There are four user modes in the drive :
•
Mode 0: Analog input controlled Open Loop PWM mode
•
Mode 1: Modbus UART ASCII Controlled Closed Loop Speed Mode
•
Mode 2: Digitally Controlled Open Loop PWM Mode
•
Mode 3: Analog Input Closed Loop Mode
Introduction – Salient Features
Page | 3