Acer Veriton FP2 Service Manual page 76

BIOS Messages
IRQ Setting Error
Expansion ROM Allocation Fail
I/O Resource Conflict(s)
Memory Resource Conflict(s)
PCI Device Error
DMI Table Was Destroyed
Press Ctrl + Alt + Esc key to enter Setup or F1 key to
continue
Press Esc to turn off NMI, or any key to reboot
Insert system diskette and press <Enter> key to
reboot
70
Action/FRU
1. Load default settings in Setup.
2. Enter BIOS Setup and set the Reset Resource
Assignments of the PnP/PCI Options to Yes, then
reboot the system.
3. Remove all adapter cards that are NOT factory-
installed, then reboot the system
1.
1. Load default settings in Setup.
2. Enter BIOS Setup and set the Reset Resource
Assignments of the PnP/PCI Options to Yes,
then reboot the system.
3. Remove all adapter cards that are NOT factory-
installed, then reboot the system.
1. Flash BIOS
1. Press Ctrl+Alt+Del to enter Setup and reconfigure the
system.
1. Press Esc to reject NMI error or press any other key to
reboot the system.
1. Insert a bootable disk into the floppy disk drive or
remove this disk if a hard disk is installed.
Chapter 4