Opening The Housing - Acer Veriton FP2 Service Manual

Opening the Housing

This section tells you how to open the housing cover when you need to install additional components inside
the system unit.
CAUTION: Before you proceed, make sure that you have turned off the system and all peripherals connected
to it.
Removing the Handle
1. To remove the handle, first remove the cable cover downward and outward, then remove the cable cover
from the system.
2. Remove the screw from the base of the unit and the three screws from the rear panel, then remove the
rear panel from the system.
3. Remove the two screws from the handle, then remove the handle from the system.
Removing the USB Board
1. To remove the USB board, first remove the front bezel from the panel gently.
Chapter 3 55