Table of Contents
Advertisement
Remove the Base Stand
NOTE:
Always remove the Base Stand when shipping the LCD.
1. Place monitor face down on a non-abrasive surface (Figure R.1).
2. Using your thumb, press the button to unlock (Figure R.4).
3. With the button pressed in, pull off the Base Stand (Figure R.4).
Connect a Flexible Arm
This LCD monitor is designed for use with a fl exible arm.
Please use screws (4pcs) as shown in the picture when installing. To meet the safety requirements, the monitor must be
mounted to an arm which, guaranties the necessary stability under consideration of the weight of the monitor.
Caution: Use ONLY the screws (4 pcs) that were removed from the stand or the specifi ed screws (Figure F.1) to avoid
damage to the monitor or stand.
To meet the safety requirements, the monitor must be mounted to an arm which guaranties the necessary stability
under consideration of the weight of the monitor. The LCD monitor should only be used with an approved arm
(e.g. TUEV GS mark).
NOTE:
Tighten all screws (recommended Fasten Force: 98 - 137 N•cm).
12 mm
4 x 12 mm with lock washer and
Specifi cations
4-SCREWS (M4)
(MAX depth: 10 mm)
If use other screw,
check depth of hole.
M4
fl at washer
100 mm
100 mm
Figure F.1
Weight of LCD assembly: 3.7 kg (MAX)
English-7
Figure R.4
Thickness of Bracket
(Arm) 2.0 ~ 3.2 mm
Tighten all screws
Advertisement
Table of Contents
