Martha Stewart Jayco Accent Chair Assembly Instruction

Table of Contents

Download this manual

Important safety instructions:

Please

read

carefully all instructions before assembling the table.

For your safety and ease, assembly by two or more adults is recommended.

Keep instructions for future use.

Do not discard any content until assembly completed to avoid accidentally discarding small parts or hardware.

Take out all parts and hardwares from box.

M8*55MM

M8*30MM

(Ø8+Ø13)*1.5MM

(Ø8+Ø21*2MM

Ø25*5MM

Assemble the chair on a flat, soft surface such as a carpet or cloth to prevent scratching.Turn the

chair seat(P2) upside down, open the zipper, comfirm direction, put chair seat(P2) on the chair

backrest(P1),fully tighten bolts(H1) and washers(H3 and H4） with allen wrench(H6) as illustration

below.

CHAIR BACKREST

CHAIR SEAT

LEFT

RIGHT

Jayco Accent Chair

1PC

2PCS

8PCS

4PCS

1PC

Page 1 of 4

Table of Contents

Do you have a question about the Jayco Accent Chair and is the answer not in the manual?

Page 1 Jayco Accent Chair Important safety instructions: Please read carefully all instructions before assembling the table. For your safety and ease, assembly by two or more adults is recommended. Keep instructions for future use. Pre-assembly: Do not discard any content until assembly completed to avoid accidentally discarding small parts or hardware.
Page 2 Step2.Tear off the cover on the gasket, paste the gasket on both ends of the foots as illustration below. (P4)RIGHT (P3)LEFT Step3.Place the side of the chair on a level surface, put on the leg, 70% tighten bolts (H2) and washers (H3and H4) with allen wrench (H6) as illustration below.
Page 3 Step4.70% tighten bolts (H2) with allen wrench (H6) as illustration below. (P3)LEFT Front back Step5.Turn the chair over, put on the leg, 70% tighten bolts (H2) and washers (H3 and H4) with allen wrench (H6) as illustration below. (P4)RIGHT back Front Page 3 of 4...
Page 4 Step6.70% tighten bolts (H2) with allen wrench (H6) as illustration below. (P4)RIGHT back Front Step7. Fully tighten the bolts as illustration below. ADDITIONAL NOTE ABOUT SAFETY: BOLTS MAY LOOSEN DURING NORMAL EVERYDAY USE. THEY SHOULD BE PERIODICALLY INSPECTED AND RE-TIGHTENED TO PREVENT DAMAGE OR INJURY. ALWAYS CHECK TO ENSURE THAT ALL HARDWARE IS KEPT TIGHTENED.