Electrolux COP720X User Manual page 40

40 www.electrolux.com
Problem
The lamp does not oper‐
ate.
The core temperature sen‐
sor does not operate.
Steam and condensation
settle on the food and in
the cavity of the oven.
The display shows "C2".
The display shows "C2".
The display shows "C3".
The display shows "F102". • You did not fully close
The display shows an error
code that is not in this ta‐
ble.
Possible cause
The lamp is defective.
The plug of the core tem‐
perature sensor is not cor‐
rectly installed into the
socket.
You left the dish in the
oven for too long.
You want to start the De‐
frost function, but you did
not remove the core tem‐
perature sensor plug from
the socket.
You want to start the Pyrol‐
ysis or Defrost function, but
you did not remove the
core temperature sensor
plug from the socket.
The cleaning function does
not operate. You did not
fully close the door, or the
door lock is defective.
the door.
• The door lock is defec‐
tive.
There is an electrical fault.
Remedy
Replace the lamp.
Put the plug of the core
temperature sensor as far
as possible into the socket.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the
cooking process ends.
Remove the core tempera‐
ture sensor plug from the
socket.
Remove the core tempera‐
ture sensor plug from the
socket.
Fully close the door.
• Fully close the door.
• Deactivate the oven
with the house fuse or
the safety switch in the
fuse box and activate it
again.
• If the display shows
"F102" again, contact
the Customer Care De‐
partment.
• Deactivate the oven
with the house fuse or
the safety switch in the
fuse box and activate it
again.
• If the display shows the
error code again, con‐
tact the Customer Care
Department.