Epson EMP-S52 User Manual page 52

Problems Solving
Image colours are not right
Check
Do the input signal settings match the
signals from the connected device?
Has the image brightness been adjusted
correctly?
Are the cables connected correctly?
Has the image contrastg
correctly?
Has the colour been adjusted correctly?
Have the colour saturation and tint been
adjusted correctly?
Only when projecting images
from a video source
Images appear dark
Check
Have the image brightness and luminance
been adjusted correctly?
Has the image contrastg
correctly?
Is the lamp due for replacement?
Nothing appears on the external monitor
Check
Are images from a port other than the
Computer port being projected?
If a composite videog
command to select the video signal format.
"Signal" - "Video Signal"
Use the "Brightness" menu command to adjust the brightness. "Image" - "Brightness"
Check that all of the cables required for projection are securely connected. sQuick Start Guide
been adjusted Use the "Contrast" menu command to adjust the contrast. "Image" - "Contrast"
Use the "Color Adjustment" menu command to adjust the colour. "Image" - "Color Adjustment"
Use the "Color Saturation" and "Tint" menu commands to adjust the colour and tint. "Image" - "Color
Saturation", "Tint"
Use the "Brightness" and "Brightness Control" menu commands to adjust the brightness and luminance.
"Image" - "Brightness"
been adjusted
Use the "Contrast" menu command to adjust the contrast. "Image" - "Contrast"
When the lamp is nearly due for replacement, the images will become darker and the colour quality will
become poorer. When this happens, the lamp should be replaced with a new one.
The only images that can be displayed on an external monitor are those from the Computer port. You
cannot output video equipment images to an external monitor.
Remedy
or S-Videog source is connected to the projector, use the "Video Signal" menu
sp.34
sp.33
Remedy
"Settings" - "Brightness Control"
sp.33
Remedy
sp.33
sp.33
sp.35
sp.33
sp.59
sp.63
51
sp.33