Cleaning And Care; Maintenance And Repairs; Spare Parts - Fein ASse 636 2b Kinetik Manual

ASse 636 -2b .book Seite 11 Donnerstag, 28. Juni 2001 8:55 08
ASse 636 - 2b Kinetik
Correct the screwing depth.
If the screw is to be screwed in deeper,
screw in the stop collar further. If the
screw is screwed in too deeply,
unscrew the collar stop accordingly.
Example: After being screwed in for the
first time, the screw is still projecting
1.5 mm from the material. Turn in the
stop collar 1.5 turns to reach the correct
screwing depth.

Cleaning and care.

!
Risk of injury
by switching the tool ON unintentionally.
Before cleaning, pull out the mains plug.
Carry out the following once a week, or
more often if the power tool is used more
frequently:
Clean the venting openings.
Blow out the motor space from outside
with dry compressed air.

Maintenance and repairs.

!
Risk of injury
Service, testing and repairs may only be car-
ried out by electrical engineers in conformity
with the regulations valid in the respective
country.
Maintenance and repairs.
We recommend our customer service
department (repair centre), FEIN author-
ized service centres and agencies.
Addresses can be found at the end of
these operating instructions and in the
enclosed safety instructions.
Please hand these operating instructions
to the repair centre. An overview of spare
parts can be found at the end of these
operating instructions.
Upon request a repair manual is sent to
the electrical engineers.
Only use original FEIN spare parts.

Spare parts.

The overview of spare parts is at the end
of these operating instructions. Quoting
the parts no. (1), order no. (2) as well as
the number of spare parts (3) facilitates
the ordering procedure.
Accessories.
Illustrations and order numbers can be
found at the end of these instructions.
Description of the accessories:
A The bit stop consists of the connecting
collar and stop collar.
B Different inserts,
shaft 1/4" hexagon
(PZ = Pozidriv, Ph = Phillips,
TX = Torx, SW = width across flats,
hexagon).
C Metal carry case
(390 x 240 x 110 mm).
D Carry case, plastic
(305 x 265 x 90 mm).
Guarantee.
FEIN power tools are guaranteed in
accordance with statutory and national
regulations (evidence of purchase by
invoice or delivery note).
Damage caused by improper handling,
overload or normal wear shall be
excluded from the guarantee.
Please contact our customer service
(repair centre), FEIN authorized service
centres or agencies.
EN
11