Schlage AD-201 User Manual page 7

Manual programming commands
Commands are confirmed by five left-right green blinks of the Schlage button.
L
Programming mode will time out if no entry is made in 20-25 seconds. Time out is
L
indicated by red blinks of the Schlage button, three left and nine right at the same
time.
An incorrect entry is indicated on the Schlage button by a solid red left LED, and a
L
blinking green right LED. To interpret blink patterns, refer to Error codes on page 9.
Function
Change
[Programming Code]
Change
Programming Card
Add Normal Use
Credential
Add Normal Use
+PIN Credential
Add Toggle
Credential
1 Other lights may show before the final confirmation. Wait for the final confirmation before continuing to the
next step.
Press/Present
[Programming Code]
New [Programming Code]
New [Programming Code]
[Programming Code]
New Programming Card
[Programming Code]
(for PIN only)
add another credential OR
[Programming Code]
add another credential OR
[Programming Code]
(for PIN only)
add another credential OR
OR Programming Card
OR Programming Card
OR Programming Card
New [PIN]
OR New Card
OR Programming Card
New [PIN]
New Card
OR Programming Card
New [PIN]
OR New Card
confirmation
to stop flashing
between each
to stop flashing
between each
to stop flashing
between each
to finish
to stop flashing
between each
to finish
to stop flashing
between each
to finish
Wait for
1
Wait for
step.
Wait for
step.
Wait for
step.
Wait for
step.
Wait for
step.
7