Brush Installation/Removal - Minuteman 200X Operation Service Parts Care

INSTALLATION
Traction Drive
1. Raise the scrubhead to the "UP" position by depressing the pedal (A) downward as shown
on Fig. 1.
Deluxe Model
1. Raise the scrubhead to the "UP" position by pressing the switch "BRUSH UP" (B) switch as
shown on Fig. 2 until the scrubhead stops retracting upwards.
2. Center brush (D) under the scrubhead shroud while lining up the center hex drive hub and
pressing the brush up until the brush engages on the drive hub.
REMOVAL
Traction Drive
1. Raise the scrubhead to the "UP" position by depressing the pedal (A) downward as shown
on Fig. 1.
Deluxe Model
1. Raise the scrubhead to the "UP" position by pressing the switch "BRUSH UP" (B) switch as
shown on Fig. 2 until the scrubhead stops retracting upwards.
2. Remove the brush (D) by stepping on the "BRUSH RELEASE PIN" on the top of the scrubhead
shroud as shown on Fig. 1 below.
Figure 1
BRUSH INSTALLATION - REMOVAL
6
Figure 2