Specifications - Makita LS0716FL Instruction Manual

SPECIFICATIONS

Model ...............................................................................................................................................................LS0716FL
Blade diameter.................................................................................................................................................... 190 mm
Hole (arbor) diameter............................................................................................................................................ 20 mm
Max. Miter angle ................................................................................................................................Left 47° , Right 57°
Max. Bevel angle.................................................................................................................................Left 45°, Right 45°
Max. Cutting capacities (H x W) with blade 190 mm in diameter.
Miter angle
0°
45° (left and right)
57° (right)
(Note)
* mark indicates that a wood facing with the following thickness is used.
1: When using a wood facing 20 mm thick.
2: When using a wood facing 15 mm thick.
3: When using a wood facing 10 mm thick.
-1
No load speed (min ) ............................................................................................................................................. 4,500
Laser Type (LS0714FL only)...................................................................................Red Laser, < 1mW ( Laser Class 2 )
Dimensions (L x W x H) .....................................................................................................670 mm x 430 mm x 505 mm
Net weight ............................................................................................................................................................ 13.7 kg
• Due to our continuing programme of research and development, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the tool. Be sure that you understand their meaning before use.
...................Read instruction manual.
...................DOUBLE INSULATION
...................To avoid injury from flying debris,
keep holding the saw head down,
after making cuts, until the blade has
come to a complete stop.
..............................When performing slide cut, first pull
carriage fully and press down handle,
then push carriage toward the guide
fence. For your safety, remove chips,
small pieces, etc. from the table top
before operation.
2
45° (left)
* 45 mm x 275 mm Note 1
40 mm x 312 mm
* 45 mm x 190 mm Note 2
40 mm x 220 mm
-----
Bevel angle
0°
* 60 mm x 275 mm Note 1
55 mm x 312 mm
* 60 mm x 190 mm Note 2
55 mm x 220 mm
* 60 mm x 150 mm Note 3
55 mm x 170 mm
................For your safety, remove chips, small
pieces, etc. from the table top before
operation.
................Do not place hand or fingers close to
the blade.
........Never look into the laser beam.
Direct laser beam may injure your
eyes.
..................Only for EU countries
Do not dispose of electric equipment
together with household waste mate-
rial!
In observance of European Directive
45° (right)
* 24 mm x 275 mm Note 1
17 mm x 312 mm
* 24 mm x 190 mm Note 2
17 mm x 220 mm
-----
END210-3