Assembly Instructions - Dyna-Glo DGA480BSN-1 Manual

ASSEMBLY INSTRUCTIONS

1. Locate the two locking casters (B) and the
two standard casters (C). Secure the two
locking casters (B) to the rear of the bottom
shelf (A) (the area with the bevel) using four
M6x12 screws (AA) inserted through four spring
washers (CC), then through four plain washers
(BB) and into the threaded holes on the bottom
shelf (A). Secure the two standard casters (C)
to the front of the bottom shelf (A) using four
M6x12 screws (AA) inserted through four spring
washers (CC), then through four plain washers
(BB) and into the threaded holes on the bottom
shelf (A). Tighten all screws.
Hardware Used
AA
M6 x 12 Screw
Spring
CC
Washer
Plain
BB
Washer
2. Insert 4 M6x12 screws (AA) halfway into threaded
holes in bottom shelf (A). Attach the cart left
side panel (D) by placing the panel keyholes
over the screw heads on left side of
bottom shelf (A). Slide the cart left side panel
(D) so that the screw head is over the smaller
part of the keyhole. Thread the screw
down snug but do not tighten as some slack
will be necessary in following assembly steps.
Repeat with cart right side panel (E).
Hardware Used
AA
M6 x 12 Screw
1
BB
x 16
x 16
x 16
2
x 4
7
C
AA
CC
AA
CC
BB
D
AA
A
B
E
A