Installing The Stainless Steel Handle; Operating Your Appliance; Control Panel For Acr45L - Summit accucold ACR45L Instruction Manual

INSTALLING THE HANDLE
This appliance includes a handle that is not required to operate the unit.
To install the handle, follow the instructions below:
1. Use a screwdriver to remove the screws on the side of door where the
handle is to be installed.
2. Align the handle with the screws removed in step # 1. Tighten the
screws using a Phillips head screwdriver until the handle is both flush
and secured tightly against the door side. (DO NOT over-tighten as
this will cause damage to the door surface.)
It is recommended you install the appliance in a place where the ambient temperature is between 72º and
78ºF (23º-26ºC). If the ambient temperature is above or below the recommended temperatures, the
performance of the unit may be affected. For example, placing your unit in extremely cold or hot
conditions may cause interior temperatures to fluctuate. The operating temperature range may not be
reached.
CONTROL PANEL FOR ACR45L THERMOSTAT
ON/OFF Power
To turn the appliance ON or OFF, press the
NOTE: Pressing the POWER key once can switch off the audible alarm when the alarm is on.
UP
Used to increase (warm) the set temperature by 1°C/1ºF.
DOWN
Used to decrease (cool) the set temperature by 1°C/1ºF.
ºF/ºCSelector
Select the temperature display in Fahrenheit or Celsius degrees. To change the temperature from
Fahrenheit to Celsius or from Celsius to Fahrenheit, press and hold the LIGHT key for 5 seconds.

OPERATING YOUR APPLIANCE

symbol and hold for 5 seconds.
8