Table of Contents
Advertisement
7.
Charge the battery pack with only the battery
charger specified by Toro. A charger suitable for
1 type of battery pack may create a risk of fire
when used with another battery pack.
8.
Charge the battery pack in a well-ventilated area
only.
9.
Do not expose a battery pack or battery charger
to fire or to temperatures higher than 100°C
(212°F).
10.
Follow all charging instructions and do
not charge the battery pack outside of the
temperature range specified in the instructions.
Otherwise, you may damage the battery pack
and increase the risk of fire.
11.
Do not operate the machine without all guards
and other safety protective devices in place and
functioning properly on the machine.
12.
Dress properly—Wear appropriate clothing,
including eye protection; long pants; substantial,
slip-resistant footwear; rubber gloves; and
hearing protection. Tie back long hair and do
not wear loose clothing or loose jewelry that can
get caught in moving parts. Wear a dust mask in
dusty operating conditions.
III. Operation
1.
Avoid dangerous environments—Do not use the
machine in rain or in damp or wet locations.
2.
Use the proper machine for your
application—Using the machine for purposes
other an its intended use could prove dangerous
to you and bystanders.
3.
Prevent unintentional starting—Ensure that the
switch is in the O
to the battery pack and handling the machine.
Do not carry the machine with your finger on the
switch or energize the machine with the switch
in the O
position.
N
4.
Do not grasp the exposed cutting blades or
cutting edges when picking up or holding the
machine.
5.
Operate the machine only in daylight or good
artificial light.
6.
Remove the battery pack from the machine
before adjusting it or changing accessories.
7.
Keep your hands and feet away from the cutting
area and all moving parts.
8.
Stop the machine, remove the battery pack from
the machine, and wait for all movement to stop
before adjusting, servicing, cleaning, or storing
the machine.
9.
Remove the battery pack from the machine
whenever you leave it unattended.
position before connecting
FF
10.
Do not force the machine—Allow the machine to
do the job better and safer at the rate for which it
was designed.
11.
Do not overreach—Keep proper footing and
balance at all times, especially on slopes. Walk,
never run with the machine.
12.
Use extreme caution when reversing or pulling
the machine towards you.
13.
Be careful when operating the machine in hard
ground. The blades can catch in the ground and
propel the machine forward.
14.
If an object becomes lodged in the blades, shut
off the machine and remove the battery before
removing the object.
15.
Start the motor carefully according to
manufacturer instructions and with feet well
away from the machine.
16.
Never transport a machine while the motor is
running.
17.
Stay alert—Watch what you are doing and use
common sense when operating the machine.
Do not use the machine while ill, tired, or under
the influence of alcohol or drugs.
18.
Ensure that the ventilation openings are kept
clear of debris.
19.
Under abusive conditions, the battery pack may
eject liquid; avoid contact. If you accidently
come into contact with the liquid, flush with
water. If the liquid contacts your eyes, seek
medical help. Liquid ejected from the battery
pack may cause irritation or burns.
20.
CAUTION—A mistreated battery pack may
present a risk of fire or chemical burn. Do not
disassemble the battery pack. Do not heat the
battery pack above 68°C (154°F) or incinerate
it. Replace the battery pack with a genuine Toro
battery pack only; using another type of battery
pack may cause a fire or explosion. Keep
battery packs out of the reach of children and
in the original packaging until you are ready to
use them.
IV. Maintenance and Storage
1.
Maintain the machine with care—Keep it clean
and in good repair for best performance and to
reduce the risk of injury. Follow the instructions
for lubricating and changing accessories. Keep
handles dry, clean, and free from oil and grease.
2.
Keep all nuts, bolts and screws tight to ensure
the machine is in safe working condition.
3.
When the battery pack is not in use, keep it
away from metal objects such as paper clips,
coins, keys, nails, and screws that can make a
4
Advertisement
Table of Contents
