Advertisement
C: Setting Maximum Brightness
The maximum brightness level provided by the timer can be set to suit customer requirements.
Note that when lamps are near to full brightness, it is difficult to see changes in dimming level. Therefore, when setting up
maximum brightness, it is recommended that the lamp is slowly dimmed up to a point where no further changes in brightness
can be seen, and the maximum level set at this point.
Step 1
Enter into the timer Setup Mode - See PART A
Step 2
Click the push button 3 times
Step 3
The LED Indicator will blink 3 times
Note: To cancel/exit do nothing for 30 seconds
Note: If more than one dimmer is connected to the same load, all dimmers connected
to this load will now blink 3 times
Step 4
Push the button to achieve the required maximum brightness level
Note: To cancel/exit do nothing for 30 seconds
Step 5
Click once to save & exit
Note: If more than one LEDsmart
brightness levels only needs to be set in one device. The setting is automatically saved
to all other devices connected in parallel
+
device is connected in parallel, the minimum
Push Button Minute Timer
5
Advertisement
