Table of Contents
Advertisement
Troubleshooting
If you experience problems with your TV, check below for advice. If you don't find a solution here, contact After Sales Support on 1300 886 649.
Problem
Check the power outlet is turned on.
If using a multi-outlet, check if it is working properly. To check whether a power strip is working properly, plug the
No power
TV's power plug directly to a wall outlet and observe its operation.
Try to power on using the button on your TV set.
Ensure that all equipment is connected properly. If you are using an external device, turn it off, then turn it on
again. If it says there is no signal on the screen, choose the correct source input.
Adjust the antenna position.
Move the TV away from electronic equipment or devices that could cause interference.
Picture issues
Auto-tune free-to-air TV channels again.
Try another channel.
If the image keeps flickering when trying to connect the HDMI cable, make sure the cable is correctly connected
to the port; and not faulty (bent or broken).
Adjust menu > Setting > HDMI EDID.
Turn off the modem and the router (if used). Wait for 2 minutes and then turn them back on.
If you are connecting using Wi-Fi, make sure you enter the Wi-Fi password correctly.
Network connection
If you are using a static IP, enter the IP address and other network addresses directly.
issues
If you are using an ethernet cable, use one rated CAT 5 or higher. Make sure it is plugged in at both ends.
If the problem persists, contact your Internet Service Provider or modem manufacturer.
Solution
TROUBLESHOOTING | 45
Advertisement
Table of Contents
