Dyna-Glo DGE530SSP Manual page 9

ASSEMBLY INSTRUCTIONS
5. Insert 2 M4x12 screws (DD) into left edge of
upper front door brace (Y), but do not tighten.
Leave 4-6mm clearance from screw head
to the bottom of upper front door brace (Y). Attach
left support for upper front door brace (U) onto the
inserted screws. Secure with 2 additional M4x12
screws (DD) and tighten all four screws. Repeat
with right support for upper front door brace (V).
Hardware Used
DD M4x12 Screw
6. Remove 2 pre-assembled M6x12 screws (AA)
and door handle sleeve (N) from the door
handle (L). Insert the 2 door sleeves (N) into
the holes located on the back of the door
assembly (J). Insert 2 M6x12 screws (AA) into
the door handle sleeve (N), through the door
handle bezels (M) and into the thread holes in
the door handles (L). Tighten the screws. As
shown on figure. Repeat with right door
assembly (K).
Hardware Used
M6x12 Screw
AA
5
Y
x 8
DD
6
L
x 4
9
V
U
DD
Y
J
M
U
H
N
AA