Dyna-Glo DGE530SSP Manual page 8

ASSEMBLY INSTRUCTIONS
3. Insert one M6x12 screw (AA) into the rear
holes of the cart left side panel and cart right
side panel (H&E), leaving 4-6mm clearance
from screw head to the side panels (H&E).
Attached the cart rear panel (I) by sliding
the keyholes in the cart rear panel over the
inserted screws and then push with force.
Secure the cart rear panel (I) to the bottom
shelf (A) using 3 M6x12 screws (AA).
Tighten the 2 screws on the side panels
(H&E).
Hardware Used
AA M6x12 Screw
4. Align upper front door brace (Y) to the holes
1 on cart left side panel (H). Secure upper
front door brace to 2 using 2 M6x12 screws
(AA). Repeat and secure upper front door
brace (Y) to cart right side panel (E).
Hardware Used
AA M6x12 Screw
3
I
x 5
4
AA
E
x 4
Y
8
AA
E
A
1
Y
H
Y
H
2
H