2. INSTALLATION
A
WARNING:When installing
the dishwasher, follow basic
precautions, including the
following:
Please check the standarts and local
•
codes for placement of machine.
Installation, maintenance and repair
•
should be performed by a qualified
installer. Work by unqualified persons
could be dangerous and may void the
warranty.
Do not operate the appliance if
•
damaged, malfunctioning, partially
disassembled or if it has missing or
broken parts.
Before installation or service,
•
disconnect the power supply to
the work area by unplugging the
unit, "tripping" the circuit breaker or
removing the fuse.
Only connect the dishwasher to the
•
power supply when all installation and
plumbing work is complete.
Never connect the ground wire to gas
•
lines, or hot water pipes, plumbing
lines.
Do not install or store the dishwasher
•
where it can be exposed to below
freezing temperatures or exposed to
weather.
Dishwasher must be secured to
•
adjacent cabinetry using the brackets
provided. Failure to do this may cause
damage to property or bodily injury.
Connect to a properly rated, protected
•
and sized power supply circuit to avoid
electrical overload. The dishwasher
is designed for an electrical supply
of 120 V (volts), 60 Hz (hertz), AC,
connected to a dishwasher-dedicated,
properly grounded electrical circuit
with a fuse or breakers rated for 15
amperes. Electrical supply conductors
shall be a minimum of # 16 AWG
copper wire rated at 75 °C (167 °F) or
higher. These requirements must be
met to prevent injury and machine
damage. Consult a qualified electrician
if in doubt.
Do not use any extension cord or
•
portable outlet device to connect the
dishwasher to a power supply.
A
WARNING:Danger of
suffocation! Ensure that any
plastic wrappings, bags, small
pieces etc. are disposed of
safely and kept out of the reach
of children.
4
USA