Table of Contents
Advertisement
machine right after washing process is completed. Slightly open the door and wait
for evacuation of the steam inside for a while. Unload the dishes after the pieces
cool down to a touchable level. Start unloading process from the lower basket. Thus,
dropping of water remained on a piece at upper basket onto the pieces at lower
basket is prevented.
Selected programme is unsuitable. >>> Since rinsing temperature is low at
•
programmes with short duration, drying performance will also be low. Select
programmes with longer duration for a higher drying performance.
Surface quality of the kitchen utensils is deteriorated. >>> Desired washing
•
performance can not be obtained at kitchen utensils with deteriorated surfaces and
it is not suitable to use such utensils in terms of hygiene as well. Also, water can not
flow easily on deteriorated surfaces. It is not recommended to wash such kitchen
utensils in dishwasher.
C
It is normal that drying complaints can be experienced with Teflon kitchen
utensils. It is associated with the structure of Teflon. Since the surface
tensions of Teflon and water are different, water droplets will remain as
beads on the Teflon surface.
Tea, cafe or lipstick stains remain on dishes.
Selected programme is unsuitable. >>> Select a programme with a higher
•
temperature and cycle time.
Surface quality of the kitchen utensils is deteriorated. >>> Tea and cafe stains or
•
other dye spots may not be cleaned in dishwasher when they have penetrated in
deteriorated surfaces. Desired washing performance can not be obtained at kitchen
utensils with deteriorated surfaces and it is not suitable to use such utensils in
terms of hygiene as well. It is not recommended to wash such kitchen utensils in
dishwasher.
Detergent is stored under unsuitable conditions. >>> If you are using powder
•
detergent, do not store the detergent package in humid places. Keep it in a closed
container if possible. For ease-of-storing, we recommend you to use tablet
detergents.
Lime traces remain on dishes and glassware gains a misty appearance
Rinse aid is not sufficient. >>> Check the rinse aid indicator and add rinse aid if
•
necessary. Increase the rinse aid setting if there is enough amount of rinse aid in the
machine.
Water hardness setting is low or salt level is insufficient >>> Measure the hardness
•
of the supply water appropriately and check the water hardness setting.
Salt leakage exists. >>> Pay attention not to spill salt around the salt filling hole
•
while adding salt. Make sure that the salt reservoir lid is tightly closed after finishing
the filling process. Run the prewash programme to remove the salt that spilled inside
the machine. Since the salt granules that will remain under the lid will dissolve during
prewash, causing the lid loosen, check the lid once again at the end of the programme.
36
USA
Advertisement
Table of Contents
