Tele System PALCO22 LED09 Manual page 40

42. Go to reference: recalls the default position of the motor (usually coinciding with
"0" degrees)
Press Exit to save settings and return to the previous screen and continue searching
channels like illustrated in paragraph 8.1.2.
1.26.2 DiSEqC 1.3
From the Antenna Setup menu make choices according to point 8.4.1 with the
exception of item 8 in which you have to set the DiSEqC 1.3 value. So it is necessary to
configure the motor defining the Western and Eastern limits, the position of the
satellite, and the geographic position of the antenna.
The Eastern and Western limits are set exactly as above (by pressing the RED button
Set limit).
The satellite position is also set as above (by pressing the YELLOW button Set Position).
The geographical location is configured by pressing the GREEN button Location:
Position: select one of the available options or Manual to enter the location manually
Longitude Direction: Choose East or West
Longitude Angle: Enter the degrees longitude
Latitude Direction: Select North or South
Latitude Angle: Enter the relative latitude degrees
Press Exit to save settings and return to the previous screen and continue searching
channels like illustrated in paragraph 1.23.2.
1.27 Automatic scanning
In the event you want to scan satellite channels (for example to update the channel
list) and the antenna system is a Simple type or a previously configured one, in the
Channels menu you have the Automatic Scan option; through it (as described in section
6.8), once you set the country and the desired satellite, you can define search
parameters as described in paragraph 1.23.2 and press OK to start loading the pre-
configured channel list or channel scan.
Security – System Block
To access the menu you must enter the password set at the time of initial installation
(default PIN: 0000).
System block
If set on ON, the access to some functions is password protected.
Blocked channel
16