Table of Contents
Advertisement
Display assembly
Description
12.1-inch, WXGA, BrightView touch-screen display assembly with Web camera, fingerprint reader,
microphones, and WLAN antenna cables
12.1-inch, WXGA, BrightView touch-screen display assembly with Web camera, microphones, and
WLAN antenna cables
12.1-inch, WXGA, BrightView touch-screen display assembly with fingerprint reader, microphones and
WLAN antenna cables
12.1-inch, WXGA, BrightView touch-screen display assembly with microphones and WLAN antenna
cables
Before removing the display assembly, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power cord.
3.
Remove the battery (see
4.
Remove the memory module compartment cover (see
5.
Remove the WLAN module compartment cover and disconnect the wireless antenna cables from the
6.
WLAN module (see
Remove the keyboard (see
7.
Remove the switch cover (see
8.
Remove the display assembly:
Close the computer and turn it upside down, with the front toward you.
1.
Loosen the Phillips PM2.0×5.0 captive screw (1) that secures the display connector cover to the
2.
computer.
Lift the rear edge of the display connector cover (2) and swing it toward you.
3.
Remove the display connector cover.
4.
NOTE:
Battery on page
WLAN module on page
Keyboard on page
Switch cover on page
The display connector cover is included in the Plastics Kit, spare part number 464114-001.
36).
Memory module on page
43).
47).
49).
Component replacement procedures
Spare part number
464144-001
464142-001
464145-001
464143-001
41).
51
Advertisement
Table of Contents
