LEGRAND 5 742 02 Quick Start Manual page 3

1
Necessary safety precautions
1
2
Install the connected switch
1
Remove
the existing
switch
2
Wire the connected switch
To ensure that your connected
switch (with dimmer option)
works correctly, you must wire
the bleeder provided as close
to the load as possible and put
a bulb in before turning the
power on.
N (neutral) = blue
L (live) = any except blue and green/yellow
(earth) = green/yellow
The connected switch (with dimmer
option) works with standard bulbs
or dimmable bulbs including LEDs
over 5 W.
Using dimmable LEDs is mandatory
for optimal installation results.
OFF
Switch OFF the power
at the main circuit
breaker
2
Make sure that the power
is OFF before continuing
with the installation.
3
‫م‬
‫ك‬
Frequency bands: 2.4 - 2.4835 GHz
Power level: < 100 mW
If you have wired your bleeder but
you are using non-dimmable LED
bulbs, it is possible that your bulbs
will not go out fully or will flicker.
3
Bleeder (mandatory)
> 5 W
< 300 W