Table of Contents
Advertisement
Useful Information
Problem
I fully charged the batteries, but
–
still flashes,
–
is displayed, or
– the operating time seems to
be shorter.
Making/answering calls, intercom
Problem
is displayed.
Noise is heard, sound cuts in
and out.
The handset or base unit does
not ring.
I cannot make local calls with
the handset using a cellular line.
I cannot make or answer
cellular calls with the handset.
For assistance, please visit http://shop.panasonic.com/support
66
Cause/solution
R Clean the battery ends (
with a dry cloth and charge again.
R It is time to replace the batteries (page 10).
Cause/solution
R The handset is too far from the base unit. Move closer.
R The base unit's AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
R The handset is not registered to the base unit. Register it
(page 44).
R You are using the handset or base unit in an area with
high electrical interference. Re-position the base unit and
use the handset away from sources of interference.
R Move closer to the base unit.
R If you use a DSL/ADSL service, we recommend
connecting a DSL/ADSL filter between the base unit and
the telephone line jack. Contact your DSL/ADSL provider
for details.
R The ringer volume for landline is turned off. Adjust the
ringer volume (page 22, 37).
R The ringer volume for cellular line is turned off. Adjust the
ringer volume (page 22, 35).
R The unit which is not selected to ring for cellular calls
does not ring. To change the selection, see page 17.
R Silent mode is turned on. Turn it off (page 41).
R The ringer volume is turned off by pressing and holding
0. Press and hold 0 again to turn it on (page 22).
R You need to add your area code when making cellular
calls. Store your area code in order to automatically add it
to the beginning of the 7-digit phone number when
making cellular calls (page 19).
R Depending on the cellular phone's compatibility (page 5),
you may not be able to make or answer cellular calls even
if the cellular phone is connected to the base unit.
R Make sure that the CELL indicator lights up and the
cellular phone is connected to the base unit (page 18).
R Only 2 Bluetooth devices can be used with the unit at the
same time (for example, 2 cellular lines, or the headset
and 1 cellular line).
R The cellular phone is being used separately from your
system.
,
) and the charge contacts
Advertisement
Table of Contents
