Table of Contents
Advertisement
Ambient Temperatures
Allow unit and engine to adjust to the outdoor
temperatures before clearing snow.
Function of Clutch
IMPORTANT: Check Clutch/Brake function before
each use. If the Impeller does not stop quickly when
the Attachment Clutch Bail is released or there is no
noticeable increase in the bail force before contacting
the Handlebar, adjust as directed in the Service and
Adjustments section, or repair before operation.
Engine Fuel and Crankcase Oil
Check and add fuel if required. Check that the engine
crankcase oil is full using dipstick.
STARTING AND SHUT-OFF
WARNING: FAILURE TO FOLLOW
INSTRUCTIONS could result in personal
injury and or damage to unit. DO NOT attempt
to start your unit at this time. Read entire
Owner/Operator Manual and the Engine
Manual first.
IMPORTANT: At start-up, allow unit and engine to
adjust to the ambient temperature before operating.
Before shut-off, run the attachment a few minutes to
prevent freeze-up.
NOTE: Try out each control without the engine running
to see how they work and what they do.
Manual Start
1. Turn discharge chute straight ahead.
2. Release auger clutch bail.
3. Push Primer Bulb 2 or 3 times for a cold engine.
NOTE: When temperature is below -15˚F (-26˚C) addi-
tional priming may be needed.
4. If engine is cold, apply choke. See Engine
Manual for detailed instructions.
NOTE: A warm engine requires less choking than a
cold engine.
5. Insert key into ignition switch and push into RUN
position.
6. Grasp starter handle and pull rope out until it
pulls harder. This is the compression stroke; let
the rope rewind slowly.
7. Pull rope with a rapid continuous full arm stroke.
Let rope rewind slowly.
NOTE: DO NOT allow starter handle to snap back
against the starter.
8. Repeat steps 5 and 6 until the engine starts. (If
engine does not start, refer to Troubleshooting.)
9. Adjust choke as needed.
10. Set throttle to "Part Throttle" or "Slow" position for
adaptation to ambient temperature. Set throttle to
"Part Throttle" position for normal operation.
Emergency Stop
Immediately release clutch bail to stop unit in an
emergency. Stop Engine, remove Key and wait for all
rotating parts to stop before leaving operator's position.
Shut-Off
1. Run Impeller a few minutes after use to prevent
freeze-up of Impeller.
2. Release Attachment Clutch Bail.
3. Move Throttle to the "Slow" Position.
4. Move key into "Stop" position.
5. Remove key.
SNOW REMOVAL
After proper Pre-Start and Starting, engage the
Attachment Clutch Bail.
IMPORTANT: DO NOT overload unit capacity by
attempting to clear snow at too fast a rate.
To clear an area, run unit in an overlapping series of
paths. For large areas; start in the middle and throw
snow to each side, so snow is not cleared more than
once.
ALWAYS direct snow away from area to be cleared and
with direction of the wind.
Snow is best removed as soon as possible after snow
fall.
TRAVELING
To travel from one work area to another:
1. Set Throttle to "Slow" position or "Part Throttle"
position.
2. Press down the handlebars enough to raise the
front of the unit slightly off surface.
3. Push unit to desired location.
TRANSPORT
ALWAYS shut off engine and remove key when
transporting the unit on a truck or trailer.
Secure unit chassis to transport vehicle. NEVER
secure by rods or linkages that could be damaged.
GB - 9
Advertisement
Table of Contents
