Table of Contents
Advertisement
1 & 2. DANGER! Rotating Parts
Read Operator's Manual.
Stop engine and remove ignition key prior to
leaving operator's position for any reason.
Read manual prior to servicing.
Rotating parts! Stop engine and remove key
before clearing. High speed impeller
rotates below discharge opening. Wait for
all moving parts to stop before servicing
unit or removing clogs.
Keep clear of auger while engine is running.
Safety
• Keep all controls, guards and safety devices
properly serviced and functional.
• Never direct discharge towards persons or
property that may be injured or damaged by
thrown objects.
3. DANGER
HOT SURFACES! DO NOT touch parts
which are hot from operation. ALWAYS allow
parts to cool.
ASSEMBLY SAFETY RULES
Read, understand, and follow all safety practices in
Owner/Operator Manual before assembling. Failure to
follow instructions could result in personal injury and/or
damage to unit.
ALWAYS remove key and/or wire from spark plug
before assembly. Unintentional engine start up can
cause death or serious injury.
OPERATIONAL SAFETY RULES
Walk Around Inspection
Complete a walk around inspection of unit and work
area to understand:
• Work area • Your unit • All safety decals
Work Area
ALWAYS check overhead and side clearances carefully
before operation. ALWAYS be aware of traffic when
operating along streets or curbs.
Keep children and people away. Keep children out of
work area and under watchful care of a responsible
adult.
NEVER allow children to operate or play on or near
unit. Be alert and shut off unit if children enter area.
DO NOT allow adults to operate unit without proper
training.
Keep area of operation clear of all toys, pets, and
debris. Thrown objects can cause injury.
Check for weak spots on dock, ramps or floors. Avoid
uneven work areas and rough terrain. Stay alert for
hidden hazards.
Avoid uneven and rough terrain. DO NOT operate near
drop offs, ditches, or embankments. Unit can suddenly
turn over if a wheel is over the edge of a cliff or ditch, or
if an edge caves in.
Falling snow, fog, etc. can reduce vision and cause an
accident. Operate unit only when there is good visibility
and light.
Personal Safety
Only trained adults may operate unit.
Training includes actual operation.
NEVER operate unit after or during the use of
medication, drugs or alcohol. Safe operation requires
your complete and unimpaired attention at all times.
NEVER allow anyone to operate this unit when their
alertness or coordination is impaired.
DO NOT operate unit without wearing adequate winter
outer garments. Wear adequate safety gear and
protective gloves. Wear proper footwear to improve
footing on slippery surfaces.
Protect eyes, face and head from objects that may be
thrown from unit. Wear appropriate hearing protection.
Avoid sharp edges. Sharp edges can cut. Moving parts
can cut off fingers or a hand.
ALWAYS keep hands and feet away from all rotating
parts during operation. Rotating parts can cut off body
parts.
ALWAYS keep hands away from all pinch points.
DO NOT touch unit parts which might be hot from
operation. Allow parts to cool before attempting to
maintain, adjust or service.
NEVER place your hands or any part of your body or
clothing inside or near any moving part while unit is
running.
DO NOT wear loose clothing or jewelry and tie back
hair that may get caught in rotating parts.
Never direct discharge towards persons or property
that may be injured or damaged by thrown objects. Use
extreme caution on gravel surfaces. Stay alert for
hidden hazards or traffic.
DO NOT throw snow any higher than necessary.
Deflected materials can cause injury and property
damage.
Always stand clear of the discharge area when
operating this unit.
Fumes from engine exhaust can cause injury or death.
DO NOT run engine in an enclosed area. Always
provide good ventilation.
Operation
Understand:
• How to operate all controls
• The functions of all controls
GB - 5
Advertisement
Table of Contents
