Unpacking The System - KAP Medical K-1 Series Operating Instructions Manual

Hide thumbs

Table Of Contents

Table of Contents

Mattress Weight Capacity:

NOTE

: See bed frame manufacturer's manual for bed frame weight rating.

K-1 & K-2 SERIES systems are used for patients who weigh between 35 lbs. and 1000 lbs.

(15 Kg. and 455 Kg.)

Replacement Mattress Standard System: 36" wide, 35-360 lbs. (15-163 Kg.)

Bariatric Mattress: 1000 lbs. (455 Kg.) maximum

Raised Side Bolster Mattress: 360 lbs. (163 Kg.)

Bariatric Raised Side Bolster Mattress: 1000 lbs. (455 Kg.)

Foam Aire Mattress: 360 lbs. (163 Kg.)

WARNING:

It is highly recommended that the K-1 / K-2 series SYSTEM always be installed on medical bed frames that

are equipped with standard hospital side rails or assist rails. Please raise all 4 side rails on the bed and

lock them in position after the patient is on the mattress. Health care professionals assigned to each case

should make the final determination whether side or assist rails are warranted after assessing patient risks

of entrapment and falls in accordance with State patient restraint legislation or facility interpretation of

such legislation.

Check that all air hoses and power cord are clear of moving bed components before placing a patient on

the bed and that the mattress system is fully inflated. Operate all bed frame motorized functions through

their full range of motion to be certain that there is no pulling, interference or pinching.

Mattress MUST fit bed frame and side rails snugly to prevent patient entrapment. See {Figure 1, Page 16}

Note: When opening the large system box or the small control unit box, ensure that the object used to open

the box does not penetrate and damage the components inside.

Components Supplied :

•

Complete Replacement Mattress System Box

1 Control Unit box & 1 Mattress

•

Overlay Mattress System Box

1 Control Unit & 1 Overlay Mattress

•

Control Unit Box

1 Control Unit

1 Operating Instruction Manual

1 Power Cord

•

Foam Aire Mattress Box

1 Foam Aire Mattress

1 Control Unit (if ordered with Mattress)

1 Hose Assembly (if ordered with Mattress)

Unpacking and Inspection:

•

Before accepting and signing for your shipment, please inspect the box or boxes for external and internal damages.

Verify that the number of boxes listed on the packing list matches the number of boxes received. Verify that no

components in your shipment are damaged or missing. Report any missing boxes, components and or damages to the

transportation carrier immediately.