Page 2
STRUCTURE 1. Module connection wire connector (IN); 2. Programming switch (SW1); 3. Module connection wire connector (OUT); 4. Operation selection jumper: in stand-alone mode in 2Voice and Ipercom systems 5. Terminal board DESCRIPTION OF TERMINALS Common reference for time slots and door opener inputs Common contact relay 2 Normally closed contact relay 2 Normally open contact relay 2...
Page 3
ACCESSING PROGRAMMING MODE Programming mode may be used to confi gure operation of the device and to save or edit access codes. Press in sequence. Enter the master password and press The device will beep 3 times to confi rm. The button turns from blue to red: the device is in programming state.
Page 4
Either hold pressed for at least 5 seconds or leave the device inactive for more than 30 seconds to quit programming mode. The red button turns blue, the device will generate a long confi rmation beep and then return to normal operation.
Page 5
Either hold pressed for at least 5 seconds or leave the device inactive for more than 30 seconds to quit programming mode. The red button turns blue, the device will generate a long confi rmation beep and then return to normal operation.
Page 6
SPECIFICATIONS Power voltage: ........................12 V~ o V ±10% Maximum draw: ........................260 mA @ 12 V~ 150 mA @ 12 V Maximum stand-by consumption: ..................105 mA @ 12 V~ 50 mA @ 12 V Maximum switchable relay load: ..................12 V~ / 24 V Inputs “A1”, “A2”...
Need help?
Do you have a question about the alpha 1168 and is the answer not in the manual?
Questions and answers