Table of Contents
Advertisement
Installing the metal mesh grease filter
1.
Insert the metal mesh grease filter.
While doing this, place the other hand under the metal mesh
grease filter.
2.
Fold the metal mesh grease filter upwards, locking it in place.
Changing the activated charcoal filter (only in
circulating-air mode)
In order to guarantee efficient odour filtration, the filter must be
serviced regularly.
The activated charcoal filters must be replaced at least every
4 months.
Notes
The activated charcoal filters are not included in the delivery.
■
The activated charcoal filters can be obtained from specialist
retailers, from our after-sales service or from the Online Shop.
The activated charcoal filters cannot be cleaned or
■
reactivated.
Note: Only use genuine replacement filters. This ensures
optimal performance of the appliance.
Trouble shooting
Malfunctions often have simple explanations. Please read the
following notes before calling the after-sales service.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out and damaged power cables replaced by one of our trained
after-sales technicians. If the appliance is defective, unplug the
appliance from the mains or switch off the circuit breaker in the
fuse box. Contact the after-sales service.
Fault table
Problem
Possible cause Solution
The appliance
The plug is not
does not work
plugged into the
mains
Power cut
The fuse is
faulty
The lighting
The LED lights
does not work.
are defective.
--------
8
Connect the appliance to
the power supply
Check whether other
kitchen appliances are
working
Check in the fuse box to
make sure that the fuse for
the appliance is in working
order
You can read about this in
the section entitled "Replac-
ing the LED lights".
Remove the metal grease filter, see the chapter Removing
1.
the metal grease filter.
2.
Undo the threaded joint on the activated charcoal filter cover.
3.
Remove the activated charcoal filter.
Insert the activated charcoal filter.
4.
Screw the cover in place.
5.
Install the metal grease filter, see the chapter Installing the
6.
metal grease filter.
Replacing the LED lights
:
Risk of electric shock!
When changing the bulbs, the bulb socket contacts are live.
Before changing the bulb, unplug the appliance from the mains
or switch off the circuit breaker in the fuse box.
:
Risk of injury!
The light emitted by LED lights is very dazzling, and can
damage the eyes (risk group 1). Do not look directly into the
switched on LED lights for longer than 100 seconds.
Important! Only use bulbs of the same type and wattage.
Lift the bulb cover slightly and move it towards the outside of
1.
the appliance.
Unscrew the bulb and replace it with a bulb of the same type.
2.
3.
Fit the bulb cover.
4.
Plug in the mains plug and switch the fuse back on.
Advertisement
Table of Contents
