Advertisement
LED
PWR(Power LED)
LNK(Ethernet LED)
LNK RT(VDSL Link)
FUL 100(LAN Link)
3.
The following table describes the DIP Switches' setting.
Off
On
Color
Status
Green
On
Green
Off
Green
On
Green
Blinking The device is sending or receiving data.
Green
Off
Green
On
Green
Blinking Handshaking/Transmit & Received data
Green
Off
Green
On
Green
Blinking The device is sending or receiving data.
Green
Off
Pin 1
Side
OT
RT
Pin 1: OT, RT switch
OT: LAN Extender acts as Central Office (CO) side.
RT: LAN Extender acts as Customer Premise Equipment (CPE) side.
Pin 2: Impulse noise protection
30a: High Speed Mode. Provides communication protection for up to 250ms
impulse
noise with latency less than 6 ms.
17a: Long Reach Mode. Direct data transmission with latency less than 1 ms.
Pin 3: Band Plan
Lights to indicate that the VDSL2 bridge had
power
The device is not ready or has malfunctioned.
The device has good Ethernet connection.
The LAN not connected.
RT mode.
The device not ready.
The device is link on 100M Full duplex and ready.
The device is link on 10M Full duplex and ready.
Pin 2
Pin 3
Channel
Rate Limit
30a
Symmetric
17a
Asymmetric
Descriptions
Pin 4
SNR
9dB
6dB
Page 6
Advertisement
