Audio Dubbing - Canon zr10. Instruction Manual

4_ZR10_E(73-85) 3/9/00 7:58 PM

Audio Dubbing

You can add sound to the original sound on a prerecorded tape from audio
products (AUDIO IN) or with the internal or external microphone (MIC. IN). The
original sound will not be erased. For best results, add sound to tapes that have
been recorded with this camera in SP mode with 12-bit sound. If there are non-
recorded portions on the tape, or portions recorded in LP mode, or with 16-bit or
12-bit, 4-channel sound, dubbing will stop. If your tape hasn't been recorded in
SP mode with 12-bit sound, we recommend dubbing your original tape onto a
blank tape using the ZR10's analog line-in function, then dubbing audio onto the
new tape. Make absolutely sure to set the audio mode of the new tape to 12-bit
and the recording mode to SP.
To connect other audio equipment:
• Do not use the yellow video terminal.
• The A/V terminal doesn't put out any video, so connect the S-video terminals
and check your TV, or check the LCD or the viewfinder as you add new sound.
Always check the new sound with the speaker or the headphones.
To connect an external microphone:
• When you add sound using the built-in microphone make sure not to connect
any cables to the MIC terminal.
• To use your TV to monitor video, connect the S-video terminal or the A/V
terminal (use only the video plug) to your TV. You can monitor the sound with
headphones.
Page 81 (1,1)
MIC
STV-250 Stereo Video Cable
A/V
IN/OUT
m
: Signal flow
OUTPUT
AUDIO
An audio device
L
(i. e. CD player)
R
81
E