Siemens WM14XMH0EU User Manual And Installation Instruction page 62

Hide thumbs Also See for WM14XMH0EU:
Table of Contents

Advertisement

en Troubleshooting
Fault
Loud noises during
the spin cycle.
Banging noises, rat-
tling in the drain
pump.
Slurping, rhythmical
suction noise.
Creasing.
Detergent or fabric
softener drips off the
seal and collects on
the door or in the seal
fold.
The spin result is not
satisfactory. The laun-
dry is too wet/too
damp.
62
Cause and troubleshooting
Appliance is not correctly aligned.
Aligning the appliance
The appliance feet are not fixed.
Secure the appliance feet. Aligning the appliance
Transit bolts have not been removed.
Removing the transit bolts
Foreign bodies have got into the drain pump.
→ "Cleaning the drain pump", Page 51
The drain pump is active, the detergent solution is
pumped out.
Not a fault – normal operating noise.
The spin speed is too high.
The next time you run a wash cycle, set a lower
spin speed.
The load is too large.
The next time you run a wash cycle, reduce the
amount of laundry being loaded.
The wrong programme is selected for the type of fab-
ric.
Select the programmes that are suitable for the
type of fabric.
→ "Programmes", Page 26
Too much detergent/fabric softener in the detergent
drawer.
When dosing liquid detergent and fabric softener,
observe the marking in the detergent drawer and
do not dose above this.
A low spin speed is selected.
The next time you run a wash cycle, set a higher
spin speed.
Start the
⁠ Spin programme.
Less Ironing
Select the programmes that are suitable for the
type of fabric.
→ "Programmes", Page 26
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
Drain pipe or water drain hose is caught or jammed.
is activated.

Advertisement

Table of Contents
loading

Table of Contents