Table of Contents
Advertisement
Fault
The door cannot
be opened.
The water is not drain-
ing.
Water is not flowing
in. Detergent is not
being dispensed.
Cause and troubleshooting
→ "Cancelling the programme", Page 41
▶
Water level is too high.
Start the Empty
▶
Power failure.
Open the door using the emergency release.
▶
→ "Emergency release", Page 65
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
▶
Drain pipe or water drain hose is caught or jammed.
Ensure that the drain pipe and water drain hose are
▶
not kinked or trapped.
Drain pump is blocked.
→ "Cleaning the drain pump", Page 51
▶
is activated.
Continue the programme by selecting
▶
and pressing Start/Reload
Empty
→ "Resuming the programme when the programme
status is Rinse Hold", Page 41
The water outlet hose is connected too high.
Install the water outlet hose at a maximum height of
▶
1 metre.
Pump cover is not correctly assembled.
Correctly assemble the pump cover.
▶
Detergent dosage is too high.
Immediate measure: Mix one tablespoon of fabric
▶
softener with 0.5 litres of water and pour the mix-
ture into the left-hand compartment (not for outdoor
clothing, sportswear or items stuffed with down).
Reduce the amount of detergent for the next wash-
▶
ing cycle with the same load.
Unapproved extension installed on the water drain
hose.
Remove any unapproved extensions from the water
▶
hose. Connecting the appliance
You have not pressed Start/Reload
Press Start/Reload
▶
The filter in the water inflow is blocked.
Clean the water inflow filter → Page 54.
▶
The tap is turned off.
Troubleshooting en
programme.
.
Spin or
.
.
59
Advertisement
Table of Contents
