In These Cases - Panasonic NR-C370GH-N3 Operating Instructions Manual

Appendix

In these cases?

The power failed.
The power plug was
disconnected.
The refrigerator is not
used for a long time.
The automatic icemaker
is not used for a long time.
→When starting to use
the automatic icemaker
again, switch on the
"AUTO ICE OFF" function.
When you move or
transport the refrigerator.
When you replace the
room lamp
18
Enfocus Software - Customer Support
● Keep the doors closed and do not store additional food.
● 「QUICK FREEZING」 stop. Reset these functions to use them after the power
recovery.
● Wait at least 7 minutes, and then plug in the power plug.
(If it is plugged in immediately, the compressor will be overloaded,
which may cause a malfunction.)
● Remove all foods and drinks and clean the refrigerator.
① Disconnect the power plug.
② Clean the compartments and the ice-making tray. (P. 1 6to P. 17 )
③ Keep the doors opened for 2 to 3 days to dry the compartments.
(When drying is insufficient, the compartment may get moldy or have a foul smell.)
● Stop ice making, with the water supply tank empty, and clean the icemaker.
① Discard water in the water supply tank.
② Stop making ice. (P. 15)
③ Discard the stored ice in the ice-making tray and the ice storage box.
If ice cubes are left for long, they may become small or stick to each other.
④ Clean the upper case in the freezer compartment, the ice shovel, the water
supply tank and the ice-making tray with water. Dry them well and then put
them back to their position. The water purification filter in the water tank
contains water. Dry it properly.
● Do not transport refrigerators in a horizontal position.
(Doing so cause a failure of pipes around the compressor possible to be broken.)
● Remove the food and drinks in all compartments and discard the remaining
water and ice. Then, move the refrigerator with at least two people.
① Remove the food and drinks and discard water in the water supply tank.
② Stop the auto ice making function. (P. 15)
③ Clean the ice-making tray. (P. 17)
④ Remove the front grille screw in the adjustable legs.
(Remove the front grille before transporting the refrigerator.)
⑤ Disconnect the power plug.
⑥ Drain water from the evaporating pan.
・Put a container not exceeding 3 cm tall
(with a volume of about 500 ml)
under the drain outlet, and take the stopper off (at the bottom on the back).
・At first, break the film inside the drain outlet to let water out.
(From the next time, you only have to take the stopper off to let water out.)
・After draining water, put the stopper back tightly
(for prevention of water leakage） .
Attention
●
If frost remains on the cooling unit (not visible from the outside) in
the refrigerator, then water may spill when it is moved.
(It takes approximately 15 hours for the frost on the cooling unit to melt after
the refrigerator power plug is disconnected.)
● When replace room lamp, please contact with your authorized dealer or
service center.
Bottom of the back
Drain outlet