Section 2 - Pre-Operation And Controls; Pre-Operation Checks & Inspection - Gradall D152 Operators Safety Manual

SECTION 2 - PRE-OPERATION AND CONTROLS

2.1 PRE-OPERATION CHECKS & INSPECTION
Complete all required maintenance before operating unit.
WARNING
OW0021
Walk around inspection must be performed at beginning of each work shift or at
each change of operator. Contact your local Division of Motor Vehicles for a list
of Pre-trip inspections that are recommended in the Commercial Driver's
License (CDL) Manual. These inspections should be performed before the
inspections on the following pages.
• Ensure all Safety decals are legible and in place. Clean or replace as required.
See page 2-5 for decal information.
• Before removing filler caps or fill plugs, wipe all dirt and grease away from the
ports. If dirt enters these ports, it can severely reduce component life.
• Check all fluid levels and refill as needed.
Note: Consult engine/chassis manufacturer manual(s) for additional engine/chassis
inspection information.
82104002
Section 2 - Pre-Operation and Controls
FALL HAZARD. Use extreme caution when checking
items beyond your normal reach. Use an approved
ladder. Failure to comply could result in death or
serious injury.
2-1