Maintenance - Husqvarna LC 247i Operator's Manual

Hide thumbs Also See for LC 247i:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
5. Charge the battery if it is weak. For more
information, refer to
To charge the battery on page
13 .
Note:
The product is automatically de-energized if
you do not operate it for some minutes. To start the
To start the product (LC 347iVX,
product again, refer to
LC 353iVX) on page 14 .
To get a good result
Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.
Do a general inspection
Clean the product
Do a check of the start inhibitor *
Make sure that the safety devices on the product are not defective *
Examine the cutting equipment
Examine the cutting cover *
Do a check of the motor brake handle *
Make sure that the ON/OFF button operates correctly and is not defective
Examine the battery for damage
Do a check of the battery charge
Make sure that the release buttons on the battery operates correctly and that the
battery locks into the product
1696 - 003 - 16.12.2021

Maintenance

Before you do
Cut in different directions each time to prevent
stripes in the lawn.
Keep the cutting cover clean. Buildup from grass
and dirt on the inner side of the cutting cover can
decrease the cutting result. Refer to
product on page 18 .
To cut grass without a grass catcher or
mulch plug attached
Lift up the rear cover and remove the grass catcher.
If a mulch plug and a mulch blade are attached,
remove them.
Close the rear cover before you operate the product.
When you operate the product, the cut grass discharges
below the rear cover.
For more detailed information, refer to
www.husqvarna.com.
Maintenance schedule
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * see instructions in
Safety on page 4 .
Each use
To clean the
Each
Monthly
season
X
X
X
X
X
X
X
X
X
X
X
17

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lc 347ivxLc 353ivx

Table of Contents