Changing Indicator Slides - Assa Abloy Corbin Russwin FE6600 Series Installation Instructions

FE6600 and BL6600 Series
Multi-Point Lock
Installation Instructions
2

Changing Indicator Slides

1. Remove snap ring.
2. Remove rotation plate, spindle, and slide.
3. Replace with alternate slide.
4. Reassemble spindle and rotation plate.
Lever or
knob
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2017, 2019, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in
whole or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Snap Ring
Rotation Plate
Spindle
Fold here according to door hand and bevel
2-1/2"
1/2" diameter hole
For metal doors:
drill two (2) pilot
holes
0.106 (#36 drill)
and tap
(#6-32 Unc)
Note:
Ensure proper orientation of VAC/OCC Slide.
5. Replace snap ring into groove in button.
Slide
Slide
Figure 4
Centerline of lockbody
1-3/8"
9/16"
9/16"
Figure 5
O V O
C A C
C C C
M19V M19S
Low side of door.
Inside LHRB
Outside RH
No bevel door
2-3/4"
High side of door.
Inside LH
Outside RHRB
Cylinder
3
FM470 03/20