Table of Contents
Advertisement
Assembly
WARNING:
THE M-750 HAS A LIP IN THE FRAME QUICK RELEASE DROP BOX.
FOR YOUR PROTECTION, THE QUICK RELEASE NUT MUST BE ENTIRELY CLEAR OF
THE LIP WHEN THE FRAME IS IN THE UNFOLDED, RIDING POSITION.
Handlebar Assembly
Your handlebar is packed, rotated 90° from down, to avoid damage during shipping. To
align your handlebar:
1.
Loosen the stem binder with a 5mm hex wrench provided in your tool kit.
2.
Turn your handlebar back to its proper position.
3.
Make sure all wires and cables are free from obstruction and not wrapped around the
stem or front fork.
4.
Align the center of your handlebar with your front wheel and tighten the stem binder
using a 5mm hex wrench.
5.
Ensure that the front fork and stem will turn easily and smoothly from side to side
without your handlebar slipping.
If you do not fully understand any of the above steps or if you think the handlebar is not
tightened properly, please contact a local TidalForce dealer or the WaveCrest Customer
Support Team at 888-880-1988.
WARNING:
DANGEROUS.
IF YOUR GRIP COMES OFF, YOU COULD LOSE CONTROL OF YOUR
BICYCLE.
A GRIP WITH THE END MISSING CAN ALLOW HANDLEBARS TO
SERIOUSLY INJURE A RIDER DURING AN ACCIDENT. PLEASE CHECK THAT BOTH
HANDLEBAR ENDS ARE PLUGGED.
REPAIR AND SECURELY GLUED OR FASTENED TO THE HANDLEBARS.
TidalForce M-750 High Performance Electric Bicycle Owner's Manual
LOOSE OR DAMAGED GRIPS ON YOUR HANDLEBARS ARE
BE SURE THAT YOUR GRIPS ARE IN GOOD
WaveCrest Laboratories
14
Hide quick links:
Advertisement
Table of Contents
