Table of Contents
Advertisement
Warning Indication
High
Exhausted
SET TO MANUAL MODE
TAPE END
LENS CAP
SET DATE/TIME!
CHECK TAPE'S ERASE
PROTECTION TAB
A. DUB ERROR!
<CANNOT DUB ON A LP
RECORDED TAPE>
<CANNOT DUB ON A
16BIT RECORDING>
<CHECK TAPE'S ERASE
PROTECTION TAB>
INSERT ERROR!
<CANNOT EDIT ON A
LP RECORDED TAPE>
<CHECK TAPE'S ERASE
PROTECTION TAB>
<CANNOT EDIT ON A
BLANK PORTION>
MEMORY IS
FULL
UNIT IN SAFEGUARD
MODE REMOVE AND
REATTACH BATTERY
OR DC PLUG
UNIT IN SAFEGUARD
MODE EJECT AND
REINSERT TAPE
* The camcorder turns off automatically. Re-check if the indication clears. When it does, you can
resume using the camcorder. If the indication remains, consult your nearest JVC dealer.
• Displays the battery remaining power.
• As the battery power comes close to nil, the battery remaining power
indicator blinks. When the battery power is exhausted, power turns
off automatically.
• Appears when you attempt to change "Menu Settings", "Backlight
Compensation" or "Manual Focus" while in AUTO mode A. (
• Appears when the tape ends during recording or playback.
• Appears for 5 seconds after power is turned on if the lens cap is
attached or when it is dark.
• Appears when the date/time is not set. (
• The built-in clock battery has run out and the previously set date/time
has been erased. Consult your nearest JVC dealer for replacement.
• Appears if a tape is loaded while the Power Switch is set to "REC".
• Blinks when no tape is loaded.
• Appears when the erase protection tab is set to "SAVE" while the
Power Switch is set to "REC".
• Appears if Audio Dubbing is attempted on a blank portion of a tape.
(
44)
• Appears if Audio Dubbing is attempted on a tape recorded in the LP
(
44)
• Appears if Audio Dubbing is attempted on a tape recorded in 16-BIT
audio. (
44)
• Appears if A.DUB (D) on the remote control is pressed when the
erase protection tab is set to "SAVE". (
• Appears if Insert Editing is attempted on a tape recorded in the LP
mode. (
44)
• Appears if INSERT (I) on the remote control is pressed when the
erase protection tab is set to "SAVE". (
• Appears if Inset Editing is attempted on a blank portion of a tape.
(
44)
• Appears when the memory card's memory is full and shooting is not
possible.
• Error indications 01, 02 or 06.
Remedy: Remove and reattach the power supply or battery.*
• Error indications 03 or 04.
Remedy: Eject the cassette and reinsert.*
Troubleshooting
Meaning / Remedy
17).
44)
44)
47
EN
20)
Advertisement
Table of Contents
