XPLORE TECHNOLOGIES iX104AtR User Handbook Manual page 88

Appendix A. Troubleshooting
Table 8 Troubleshooting (continued)
Problem
Display screen is blank or difficult
to read.
Cursor is not tracking the pen.
Computer is not responding to the
pen.
88
Possible cause and solution
• Confirm that the computer is on (the Power icon is displayed
continuously in the Status area).
• The brightness may be set too low, causing the screen to
appear too dark. To change system brightness, press the Fn
and Start keys to open the Xplore menu and adjust the
brightness. (See page 32.)
• An external monitor may be selected. Press the Fn and P1
keys to select the computer display screen. (See page 32.)
• The video time-out may have expired. Tap the display
screen to reactivate the display.
Note: This is a normal, power-saving feature.
• If the Status light is blinking red, the computer is in Suspend-
to-RAM mode because the temperature is below -20° C or
above 60° C. When the temperature returns to a safe
operating range, the display screen automatically comes
back on. If possible, move the computer to a warmer or
cooler location.
• If the Status light is continually yellow, the computer is in
Suspend or Hibernate mode. Press the Power On/Off key to
resume.
Calibrate the pen. See "Calibrating the digitizer" on page 79.
Connect an external USB keyboard to the computer. If the
computer does not respond to the external keyboard, the
application or operating system may have been corrupted.
Press the Reset key. (See page 37.) If the system responds to
a keyboard but not to the pen, contact your local help desk or
reseller for further assistance.
iX104AtR User's Handbook