Toshiba RBC-AMSU51 -ES Installation Manual page 23

CAUTION
Do not perform the forced test mode for purposes other than the test mode because it applies an excessive load to the
devices.
Field setting menu(1/2)
1.Test mode
2.Register service info.
3.Alarm history
4.Monitor function
5.Setting louver position
Return
Set
Test mode
Test mode start.
Return
Yes No
(1)
Room A
Test
Cool
Mode Fan Speed
(2)
Room A
Test
(3)
Test mode
Test mode stop.
Return
Yes
12:00
12:00
No
.
1
Push the [
"1. Test mode" on the "Field setting menu"
screen, then push the "
F2] button.
Pushing the "
sets the test mode and the screen returns to the
"Field setting menu" screen.
Push [ CANCEL] twice, the screen (2)
appears.
2
Push the [
test mode. The screen (1) shown in the left
appears. (The screen (2) appears when the
operation is stopped.)
Perform the test mode in the "Cool" or "Heat"
mode.
Temperature setting cannot be adjusted during
the test mode.
Check codes are displayed as usual.
3
When the test mode is finished, push the
∧
[ ] / [
mode" on the "Field setting menu" screen,
then push the "
button.
The screen (3) appears.
Pushing the "
stops the test mode screen and continues the
normal operation.
NOTE
The test mode stops after 60 minutes and the screen
returns to the normal / detailed display.
– 22 –
Installation Manual
∧ ∨
] / [ ] button to select
Set" [
Set
Yes" [ F1] button
Yes
ON / OFF] button to start the
∨
] button to select "1. Test
Set" [ F2]
Set
Yes" [ F1] button
Yes
EN