Toro Z MASTER 4000 Series Service Manual page 54

Left Console Removal (continued)
Left Console Installation
Chassis: Service and Repairs
g346223
4. Disconnect the wiring harness from the USB charger.
5. Remove the 2 (5/16 inch) lock nuts and carriage bolts securing the LH
console to the chassis.
6. Lift the LH console away from the machine.
1. Install the LH console onto the machine.
2. Install and tighten the 2 (5/16 inch) lock nuts and carriage bolts securing the
LH console to the chassis.
3. Connect the wiring harness to the USB charger.
4. Install the LH side pod to the LH console. Install the 4 (1/4-20 inch) torx
screws securing the LH side pod to the LH console.
Note: 3 screws are shown in the image below.
g346223
5. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
Figure 28
Figure 29
Page 5–14 4000 Series Z MASTER® Service Manual
3442-427 Rev A