Table of Contents
Advertisement
2.3 Additional safety instructions for universal grinding machine
The machine must be properly grounded.
Unplug from the electrical current before repairing the machine.
The supply voltage must not exceed 10% of the rated voltage of the machine,
otherwise the electrical components can be damaged.
Safety guards in the wheel should be complete and in good condition without
being disassembled or modified by accident.
In order to prevent accidents, do not touch the power steering or electric
switch involuntarily.
When the piece is about the grinding wheel or grinding wheel is under review,
power supply should be soft and slow enough to maintain security.
When the part is released, or goes out, or the grinding wheel is damaged,
immediately stop the machine to avoid accidents.
If the machine is not used for more than a month in a wet season, the
electrical components must be inspected before use. First, allow the engine to
idle for a half hour in one third of the voltage specified to remove moisture, if
necessary. Then the machine can run at full voltage.
Changing the workhead bearings should measure the position of the inner and
outer shaft bearing and adjust the difference in length of the inner and outer
grinding wheel holder accordingly. If you can not adjust, change the inner and
outer grinding wheel holder and then change the bearings.
2.4 Forbidden use
Never use the machine outside the limits specified in this manual.
Using the machine without the safety devices is forbidden.
The dismantling or disabling safety devices are forbidden.
It is forbidden to use the machine with materials that are not explicitly
mentioned in this manual.
Any change in the design of the machine is inadmissible.
Use of the machine for purposes that are not 100% equivalent with the
instructions in this manual are forbidden.
! 7
C/Casanovas 1, 08782, St. Joan Samora - Barcelona (Spain) - Phone +34 932 935 178 - info@elite.cat
Advertisement
Table of Contents
