Table of Contents
Advertisement
5. ADJUSTMENTS
5.1 Workhead race
The grinding workhead is fixed to the column. The steering wheel of the
workhead in the upper column can move. When the steering wheel is turned a
circle, the workhead moves 2mm. When the steering wheel is turned a
division, the workhead moves with precision of 0.02mm.
The wheel shaft is connected to the motor shaft. The axis angle grinding wheel
can be adjusted by the adjusting lever (7).
The grinding workhead can be adjusted by loosening the two bolts. The safety
cover can be rotated to 360º by the screw (10) on top of the cover.
5.2 Worktable
There is a T-slot of 14 mm wide at the worktable, which can be set any
accessories in a proper position. The movement is done with the steering
wheel (14).
The worktable race can be adjusted with the lock position (5) on the side of the
column. The adjusting knob (4) can be used to adjust the table accurately. The
steering wheel (14) is to allow movement of the table again.
5.3 Work sliding table
The work sliding table can be moved 150mm forward and backward. When the
steering wheel (6) rotates a circle, the sliding table moves 3mm. A division on
the scale shows the movement of 0.03mm.
C/Casanovas 1, 08782, St. Joan Samora - Barcelona (Spain) - Phone +34 932 935 178 - info@elite.cat
16
!
Advertisement
Table of Contents
