Table of Contents
Advertisement
3. SETTING
3.1 Preparation
3.1.1 Delivery of the goods
At the time of the delivery, check that all parts are fine. If you notice damage
or missing parts of the machine, contact your dealer or carrier immediately.
You must immediately notify your dealer of visible damage, under the
provisions of the warranty, otherwise the goods will be considered suitable for
the buyer.
3.1.2 Unpacking
The machine is shipped from the manufacturer in a box or pallet carefully
packed. When the wooden box is elevated Look out the box stand firm, do not
swing. Open the box carefully.
When installing the machine, the body and the base of the machine must be
level, should not rock.
3.1.3 Surface preparation
The machine parts that are not painted carried a thin layer of oil factory
applied.
Clean them before using the machine using a common solvent avoiding nitro
solvent or similar, and never use water.
NOTE
The use of paint thinners, gasoline, corrosive chemicals or abrasives can
damage the surface of the machine!
Thus:
When cleaning, use a mild cleanser.
3.1.4 Working place
Select a suitable location for the machine.
Note the safety requirements of Chapter 2, and the dimensions of the
machine.
The site chosen should have a proper connection to the electrical current.
Make sure the floor can support the weight of the machine. The machine must
be leveled simultaneously at all points.
C/Casanovas 1, 08782, St. Joan Samora - Barcelona (Spain) - Phone +34 932 935 178 - info@elite.cat
10
!
Advertisement
Table of Contents
